Manual REFLEX CMM

Down load Brochure

micro-hite 3D CMM
Coordinate Measuring Machine

Available in two sizes:

Model 454 460x510x420mm (18.1 x 20 x 16.5") XYZ

Model 474 400x700x400mm (18.1 x 27.5 x 16.5") XYZ

Prices Start Under $20,000

The TESA MICRO-HITE^® 3D coordinate measuring system is an affordable high accuracy measuring instrument designed to fill the operational gap between precision hand-held measuring instruments and high end coordinate measuring machines. To assure its high production standards, this advanced measuring system is produced at the TESA factory in Renens, Switzerland in a dedicated manufacturing cell.

Interactive TESA REFLEX^TM software allows operators of all skill levels to perform complex inspection routines quickly and efficiently with little training. The offset triangular bridge design provides a low center of gravity and optimum stiffness-to-mass ratio. Air bearings ensure frictionless motion in all three axis.

All operations are controlled through an ergonomically positioned operator interface panel. The patented Zmouse^TM provides instant control of the measuring system from anywhere in the work envelope.

The TESA MICRO-HITE 3D coordinate measuring system comes equipped with either of two TESA 3D probes—the TESASTAR^® Touch Trigger Probe or the TESASTAR-i^® Indexable Probe. This competitively priced three-axis measuring system is designed to fit any shop budget, and offers sophisticated measurement and inspection capability for any type of manufacturing operation.